Ryse Energy Wind Turbines & Towers (Formerly Primus)

AIR wind turbines allow you to harness the wind's energy to charge an off-grid batter bank. The best-selling small wind generators in the world, AIR turbines are great for sailboats, RVs, remote cabins, and offshore platforms.

The AIR wind turbine incorporates a three-phase brushless permanent magnet alternator and integrates microprocessor-based charge controller to optimize its power production capability. The microprocessor continuously adjusts the loading of the alternator to keep the turbine operating efficiently in most wind regimes.



The AIR Breeze is designed for battery-charging applications in coastal areas, on boats, and for other marine uses. Corrosion-proofed for use in caostal and nautical applications, it has a white poweder-coated housing and sealed electronics designed to rpevent damage from salt spray. Rated power: 160W at 28mph (12.5 m/s). CSA Listed for the US and Canada. Lifetime limited warranty.

The Air 40 provides energy for off-grid homes, water pumping, lighting, telecom and anywhere you need electricity and have average annual wind speeds under 15mph. It has a bare aluminum finish for use in non-corrosive environments, so it is not suitable for marine use. Rated power: 160W at 28mph (12.5 m/s). CSA Listed for the US and Canada. Lifetime limited warranty.

The Air 30 is the best choice for reliable battery-charging in very high wind areas (above 15mph average annual wind speed). The Air 30 has lower energy production at lower average wind speeds than either the AIR Breeze or the AIR 40. It has a bare aluminum finish for use in non-corrosive environments, so it is not suitable for marine use. Rated power: 400W at 28mph (12.5 m/s). CSA Listed for the US and Canada. 5-year limited warranty.

All units weigh 13lbs, have a 46" rotor diameter (11.5 ft² swept area) and mount on a 1.5" Schedule 40 steel pipe (1 7/8" [48mm] outer diameter). Made in the USA.

 
 

Approximate Monthly kWh Production Average Annual Wind Speeds

Model

mph ->

8

9

10

11

12

13

14

16

18

DC Battery voltage

Item code

m/sec -->

3.57

4

4.5

4.9

5.36

5.8

6.25

7.15

8

AIR Breeze Marine

13

17

22

28

38

43

50

--

12

016-00987

24

016-00989

48

016-00990

AIR 40

13

17

22

28

38

43

50

--

12

016-01038

24

016-01039

48

016-01040

AIR 30

7

10

14

20

25

31

35

50

60

12

016-01032

24

016-01035

48

016-01037

 
AIR Tower Kits
 

AIR tilt-up tower kits are available as hardware kits (not including the tower pipe) in 27' (8.1m) and 45' (13.5m) heights, and in a 29' (8.8m) EZ Tower™ kit that includes the pipe for the tower. All towers use a 4-guy-wire set-up, and are assembled on the ground with the wind generator and tilted up into place.

The 27' and 45' tower kits come with all the hardware necessary to install a tower, except guy-wire anchors, pipe, and concrete. All parts bolt or clamp together and no welding is required. Purchase 1-7/8" steel tubing from a local chain link fence supplier (for up to 90mph at 27', or 70mph at 45'), or use 1.5" Sch 40 Galvanized water pipe (1-7/8" OD and up to 120mph at 27' and 90mph at 45'), to build the tower. These tower kits include a simple elbow/tee for its basethat, when combined with a short length of pipe, eliminates the need for a concrete pad, a base plate and a swivel for the base of the tower. Two people are required to erect one of these towers, but no winches or vehicles are needed.

The 29' EZ Tower™ kit comes with all the parts you'll need, including Galvanized tubing, cable and hardware. This tower uses lightweight tubing while providing plenty of strength to withstand winds up to 110mph. Two people can easily erect the EZ Tower™ without winches or vehicles. The EZ Tower™ includes a simple yet effective tower base and anchoring system which eliminates the need for a concrete pad. The kit comes with guy-wire anchors that are driven into the ground (depending on the soil conditions, concrete may be necessary for proper guy anchoring). Ships via UPS anywhere in one 74' (1.9m) box weighing 80lbs.

AIR towers are PE stamped and approved for the California buy-down program. Contact us for wet seal stamps (additional cost).

The AIR Marine Tower is the easiest way to mount your AIR Breeze Marine turbine on a boat. It's simple to install on wood or fiberglass decks. The 9' (2.7m) white powder-coated aluminum mast has an outside diameter of 1.9" (48mm) and two 9' (2.7m) long fully-adjustable stays with a 1' (25.4mm) outer diameter. The Hardware Kit contains stainless-steel hardware with self-locking nuts, and vibration mounts to minimize sound transmission. Designed to withstand hurricane-force winds. Order the Mast and hardware kit separately.

Roof mounts are also available and include vibration isolators, wall brace clamps and a safety leash, but do not include pole or lag screws. Caution should be exercised with roof mounts as wind turbines can transmit vibration into a building, causing stress on the structure, and any occupants inside. Mounting on wood-framed living structures is not recommended.



Earth auger sets
 

Screw-in "auger" type guy anchors can be used in loamy and gravelly soils. Other soil types may require concrete footings or expansion bolts. Consult an engineer or geologist if you have questions about guy supports.


MidNite Solar Stop Switch
 

MidNite Solar's Stop Switch allows you to stop an AIR wind generator and disconnect it from the battery, all with one motion. NEMA 1 indoor enclosure.



 

Model

Description

Item code

1-TWA-20-03

Marine Tower Hardware kit

016-01128

1-TWA-20-02

9' AIR Marine aluminum mast and 2 stays

016-01131

1-TWA-19-02

Roof Mount kit without roof seal

016-01134

1-TWA-19-01

Roof Mount kit with roof seal

016-01137

2-TWA-100

Roof Seal – for roof mount kit

016-01140

1-TWA-10-01

27' AIR guyed tower kit

016-01086

1-TWA-10-02

45' AIR guyed tower kit

016-01092

1-TWA-11-01

29' EZ Tower kit including pipe and anchors

016-01081

1-TWA-12-01

36" Auger – set of 4; use with 24' & 27' towers

016-01113

1-TWA-12-02

36 Galvanized auger set of 4; for 24' & 27' towers

016-01116

1-TWA-12-03

48 Auger set of 4 32' - 50' towers

016-01119

1-TWA-12-04

48 Galvanized auger set of 4 32'-50' towers

016-01122

2-ARAC-101

AIR Stop Switch (not code compliant)

016-01351

--

MidNite Solar Stop Switch (code compliant)

053-00121

3-ELOT-1147-01

5 amp circuit breaker kit - for 48 V AIR Breeze/AIR-40

053-17005

3-ELOT-1147-02

10 amp circuit breaker kit - for 24 V AIR Breeze/AIR-40; 48 V AIR-30

053-17006

3-ELOT-1147-03

20 amp circuit breaker kit - for 12 V AIR Breeze/AIR-40; 24 V AIR-30

053-17007

3-ELOT-1147-04

40 amp circuit breaker kit - for 12 V AIR-30

053-17008

3-ELOT-1147-05


  Related Categories


Twitter
Stumbleupon
Reddit
Pintrest
Newsvine
Linkedin
Google+
Google
Facebook
Digg

QUOTE

  ME

Quote Request